We specialize in hard to find items
All Categories
Bull Ring Retractable Truck Bed Tie Down Anchors, 98-12 Ford Ranger, 98-14 F150, 98-16 F250 & F350 Super Duty, 99-13 Silverado, 99-13 Sierra 1500 2500 & 3500, 95-18 RAM 1500 2500 & 3500 (1 Pair)
Share Tweet
*Price and Stocks may change without prior notice
*Packaging of actual item may differ from photo shown
- Electrical items MAY be 110 volts.
- 7 Day Return Policy
- All products are genuine and original
- Cash On Delivery/Cash Upon Pickup Available
Bull Ring Retractable Truck Bed Tie Down Features
-
Fitment Guide: 98-12 Ford Ranger, 98-14 Ford F150, 98-16 Ford F250 & F350 Super Duty, 99-13 Chevy Silverado, 99-13 GMC Sierra 1500 2500 & 3500, 95-18 Dodge RAM 1500 2500 & 3500
-
Quick Install: No Drilling, No Special Tools, 2009-2018 Dodge RAM Models Require Modification – See Details in Product Description below
-
Easy Use: Polished Finish, Fully Retractable Raised Fit, Snaps Up – Snaps Down, No Rust, No Rattle
-
Strong & Secure: 1,000lb. Capacity, Stainless Steel Ring, Stainless Steel Chassis
-
Serviced in the USA: Lifetime “No Bull” Warranty
About Bull Ring Retractable Truck Bed Tie Down
Bull Ring 4003 Fitment: 98-12 Ford Ranger|98-14 Ford F150|98-16 Ford F250 & F350 Super Duty|99-13 Chevy Silverado|99-13 GMC Sierra 1500 2500 & 3500|95-18 Dodge RAM 1500 2500 & 3500 Modification Required for Install on: Dodge RAM Models 2009-2018 Installation: Requires only a Phillips head screwdriver. 1. Remove plastic cap that covers stake pocket.2. Use Phillips screwdriver to loosen the two screws in the anchor so that the steel plate drops down. 3. Place the anchor into the stake pocket at an angle. 4. Pull the anchor ring up so that the steel plate catches on the metal rail cap below and tighten down the Phillips screws until they are hand tight (if the plastic rail cap bends/bows – it’s too tight). Dodge Ram 2009-2018 Installation:09-18 Dodge trucks have stake pockets that are hidden by plastic rail caps and require a quick trim of the plastic for the anchor points to be installed. We recommend our Router Bits #5566 & #5567 Front Stake Pockets – The scribe lines in the front of the rail caps are larger than the stake pocket underneath. For installation use our Router Bit to easily trim out the top plastic rail to match the steel pocket underneath. Our Router Bit runs along the steel pocket as a guide. Using this Router Bit gives you a perfect cut and allows you to then place our Retractable Anchor. Rear Stake Pockets – The rear stake pockets appear to be open, but have a plastic lip that covers over the metal bed. For our retractable anchors to be installed, that plastic lip must be removed. Use our Saw Blade Bit to cut the plastic lip just below the metal, then use our Router Bit to clean up the plastic on top. Alternatively, you can use a razor blade to cut the plastic rail. The scribe lines on the rear of rail caps are correct - so carefully use a blade to cut out the plastic square along those scribe lines. Then remove the plastic piece and install our retractable anchor.
