We specialize in hard to find items
All Categories
Myung Youn Electronics Single Phase to 3 Phase Converter, MY-PS-20 Model, Suitable for 15HP(11Kw) 45 Amp 200-240V 3 Phase Motor, One DPS Should Be Used for One Motor, Input/Output 200V-240V
Share Tweet
*Price and Stocks may change without prior notice
*Packaging of actual item may differ from photo shown
- Electrical items MAY be 110 volts.
- 7 Day Return Policy
- All products are genuine and original
Myung Youn Electronics Single Phase to 3 Phase Features
-
Excellent start-up torque / The size is small & easy to install
-
The efficiency of our DPS is excellent more than other items
-
The failure rate is very low
-
Semi-permanent lifetime
-
Due to sealed type, very strong against dust, moisture, and heat
-
Doesn't make any high frequency
-
Designed to be non-thermal
-
3 phase motors can be used at your home or workshop
About Myung Youn Electronics Single Phase To 3 Phase
▷ Before ordering our DPS, you should check the ampere of your motor and purchase the suitable our DPS. And please give us the information about your motor purpose to recommend suitable DPS to you. Also, please note the below points carefully. 1. MY-PS-20 model is best for 15HP motor.(11KW, 45 amps) 2. It should only be used for one motor per one DPS. The use of multiple motors is not allowed in our DPS. 3. The input/output voltage of our DPS is 200v~240v. 4. Our DPS is designed to be suitable for use in motor. 5. The efficiency is around 90~95%. 6. The voltage of motor should be 200v~240v. If the voltage of your motor is 380v or 440v, you should change the wire of motor to 200v~240v purpose to connect with output of our DPS. 7. The thickness of wires should be suitable for amperes. 8. Only single phase motor brake is allowed.(Three phase motor brake is not working at our DPS) 9. You could check three phase on the output of DPS when your motor is running. If your motor is not running, you could not check three phase from output of DPS. 10. If your motor has magnetic starter, or electronic switch, or brake, the operating wires of this device should be connected on “U” and “W” of output of our phase converter. Thus, if your motor is not running well or the motor is reversing, you should turn off the power immediately and you have to switch the wires on output(U, V, W) of our phase converter. Actually, when you connect the wires from output of phase converter to your motor, you could succeed in first time, or second time, or third time. A. Detail information 1. Capacity : Suitable for 15HP motor(11KW, 45 amps) 2. Frequency : 50/60 Hz 3. Dimension(inch) : 5.7x5x9(WxLxH) 4. Mounting holes : 5Ø 5. Net Weight : 5.2LB 6. Voltage of input and output : 200V - 240V
