We specialize in hard to find items
All Categories
FLIPSKY 75100 Pro with Aluminum PCB Based on VESC for Electric Skateboard/Scooter/Ebike Speed Controller
Share Tweet
*Price and Stocks may change without prior notice
*Packaging of actual item may differ from photo shown
- Electrical items MAY be 110 volts.
- 7 Day Return Policy
- All products are genuine and original
- Cash On Delivery/Cash Upon Pickup Available
FLIPSKY 75100 Pro with Aluminum PCB Based on VESC Features
-
75100 Pro Size: L103mm*W58mm*H27.7mm
-
Support BLDC square wave mode control and FOC sine wave mode
-
Programmable：Based on VESC, programmable via vesc_tool with overheat and overcurrent protection.
-
More powerful :Voltage:14-84V (4-20S) ，Max Current:120A,ERPM:150000 .Provide your electric skateboard with more powerful power and a more exciting modification experience.
-
Widely applications:e-skateboard,ebike,scooter,robot etc
-
Please be careful to limit the Absolute Maximum Current below 250A,setting page
-
Top Service: If there are any question or need help , just feel free contact us , we will always here help you out within 24 hours.
About FLIPSKY 75100 Pro With Aluminum PCB Based On VESC
Warm tips:It is recommended to keep firmware 5.2 from factory ship, the new firmware upgrade may damage the ESC. Please be careful to limit the Absolute Maximum Current below 250A,setting page Specs: 75100 Pro Size: L103mm*W58mm*H27.7mm Voltage:14-84V (4-20S) Current:100A Continuous,burst 120A BEC:[email protected] Support BLDC square wave mode control and FOC sine wave mode Firmware: latest (firmware update supported) ERPM:150000 Control Interface Ports:USB,CAN,UART Supported Sensors:ABI，HALL，AS5047，AS5048A Input Set Support:PPM，ADC，NRF,UART Wire Size: 10AWG(75100 Pro) Programmable: Yes Regenerative Capacity: Yes Newly upgraded: Change connection wires from 12Awg to 10Awag. More sensitive temperature detection function Integrated bluetooth module design Size & design upgraded Warm tips: Phase filering is not available for Flipsky ESC75100 and 75200! Please turn off the phase filter function and choose "false" in vesc_tool when use firmware version on or above 5.3 (VESC_TOOL 3.01). Without turning off the phase filter will result in esc damage. Please do not restore the default parameters when using the wizard interface.
