We specialize in hard to find items
All Categories
MOOCY 2Pcs Wall Art Warhawk Shark Tiger Vinyl Sticker Waterproof DIY Funny Graphics Accessories for Car Kayak Canoe Fishing Boat Truck Jet Ski Hobie Dagger Ocean Boat Decoration
Share Tweet
*Price and Stocks may change without prior notice
*Packaging of actual item may differ from photo shown
- Electrical items MAY be 110 volts.
- 7 Day Return Policy
- All products are genuine and original
- Cash On Delivery/Cash Upon Pickup Available
MOOCY 2Pcs Wall Art Warhawk Shark Tiger Vinyl Features
-
The shark teeth mouth stickers are made of high quality PVC, waterproof, non-toxic and durable.
-
Shark Teeth Size: approx. 33x16.4cm / 13.03x6.46 inch.
-
Easy to apply and removes with no residue or damage to the surface.
-
Waterproof, very strong and durable will take a beating from docks and trailers and salt water（Do not put the kayak in water in 48 hours after installation).
-
This shark teeth mouth pieces are made to fit the kayaks canoe, fishing boat, dinghy etc.
About MOOCY 2Pcs Wall Art Warhawk Shark Tiger Vinyl
INSTALLATION Step 1:Clean the area thoroughly with rubbing alcohol. Do not use Windex or similar products because it will leave a residue behind that will prevent the decal from adhering well. Step 2:Place the sticker in the desired location. Put a piece of masking tape down the center of the sticker to hold it in place. Step 3:Lift one half of the sticker up and peel off the white paper backing. Hold the sticker away from the paper backing taunt but be careful not to pull the masking tape off. Cut the Peeled paper backing off. Step 4:Slowly lower the sticker by rubbing it in place with a felt squeegee or a credit card wrapped in a sock. Start at the middle and then work your way out to the edges. Step 5:Fold the remaining half back and remove the paper backing. Slowly lower the sticker by rubbing it with the felt squeegee or sock covered credit card. Start at the middle and work to outer edges. Step 6:For best results do not apply a sticker in extreme hot or cold temperatures. Step 7:Use a pin to poke any air bubbles in the center and push the air out through the hole.
