We specialize in hard to find items
All Categories
PChero 2Packs L298N Motor Drive Controller Board Module, Dual H Bridge DC Stepper For Arduino Smart Car Robot
Share Tweet
*Price and Stocks may change without prior notice
*Packaging of actual item may differ from photo shown
- Electrical items MAY be 110 volts.
- 7 Day Return Policy
- All products are genuine and original
About PChero 2Packs L298N Motor Drive Controller Board
Why CHOOSE PChero Motor Drive Controller Board Moduld? Reason 1: Use L298N for Main Chip L298N is a kind of high voltage, high current motor driver chip. Having 15 pins as package, this chip has such features as high working voltage(maximum voltage up to 46V),large output current(instantaneous peak current up to 3A, continuous working current 2A) and 25W of rated power. Two built-in H birdge high voltage and large current full bridge drivers can be used to drive the DC motor and stepper motor, relay coil and so on.Using standard logic level signal control, it has two enable control ends. It permits or prohibites device having a logic power supply input without the impact of input signal, which enables the internal logic circuit part works at low voltage. The chip can connects to external detecting resistor to give the variations to the control circuit. Using L298N chip to drive the motor, this chip can drive a stepping motor or four phase stepping motor, and two DC motors as well. Reason 2: Wide Application PChero L298N Motor Drive Controller Board Mould is ideal for Arduino, Smart Car, Power UNO, MEGA R3, Mega 2560, etc. Specification - Chip: L298N Logic voltage: 5V Logic current 0mA-36mA Maximum power: 25W Drive voltage: 5V-35V Drive current: 2A(For each DC motor) Dimension: 43*43*27mm/ 1.69*1.69*1.06 inch Operating mode: Dual H-bridge driver (can drive 2 DC motors) Attention - This module has a built-in 5V power supply, when the driving voltage is 7V-35V, this supply is suitable for power supply. If driving voltage is more than 12V, please use external 5 Volt logic outputs to switch the H-bridge circuits. DO NOT input voltage to +5v supply interface, however ledding out 5v for external use is available. Package Included - 2 x L298N Motor Drive Controller Board Module
