All Categories
How to install 1. Take out the rear light and bracket from package, and bracket hold towards light, lock by screw. 2. Install the rear light on bicycle seat tube, lock by screw. if too loose ,rubber belt is suggested to put inside.(suitable seat tube:25-32mm) 3. The degree of the rear light could be adjusted, cyclists could adjust the degree. 4. Install on the bicycle handlebar, fix well by screwdriver. Remote control suit to 18-20mm handlebar How to use? Long press the button to on light, it is on the right side of the tail light when facing forward on your bike.(long press off) Once the button is pressed for a few seconds, the light glows very brightly. With the included remote, you can easily signal left, right, strobe, constant Is there a low battery alert? Of course, When light off, short press on/off button, red LED light will show current power, totally 5 grade. It is very convenient to control power, efficently avoid turn off. When power is lower than operating voltage, red LED will blink 3 times then off. Light couldn't on when in off condition Can I use it in rainy day? This bike light is IPX4 waterproof, if you ride in a heavy rain I would strongly suggest you to add some sealant to prevent water from going in. How long about charging time? Rear light charging time: charging take 2 hours. When charging red light lihgt on. Full charge the red light turn into the green light Warm Tips: 1.Please charge this light if 3 months no use, otherwise may cause battery less charged. 2.IPX4 waterproof. Could be used in small to moderate rain, please don't suck the product into water. Includes: 1 x Smart Taillight 1 x USB Cable 1 x Manual