Kenwood eXcelon X301-4 Power Car Amplifier Class D 4-Channel

Pay with

Kenwood eXcelon X301-4 Power Car Amplifier Class D Features

• The amplifier design is Class D, which uses digital switching power supplies. The result is the amplifier runs more efficiently, generating less heat than Class AB amps.

• The amplifier has a signal-sensing turn-on circuit. When a signal is detected on the inputs, the amplifier will automatically power on.

• The X301-4 features independent controls for the front channels (1+2) and rear channels (3+4).

• he Bass Boost increases the bass signal, centered at 40Hz. The rotary control lets you adjust the boost between 0dB and18 dB, with markings at 0dB, 1dB, 3dB, 5dB, 8dB, 12dB, and 18dB.

• The amp has 3-way switches to let you configure the channel pairs to high-pass, low-pass, or full range (crossover off). The rotary controls adjust the crossover frequency between 50Hz and 200Hz, with markings at 50Hz, 80Hz, 100Hz, 150Hz, and 200Hz.

About Kenwood EXcelon X301-4 Power Car Amplifier Class D

The 4-channel Kenwood Excelon X301-4 amplifier can dish out 50 watts RMS each to four speakers, yet still fit almost anywhere in your vehicle. For applications that require more power, you can bridge the amp to 2-channel mode to drive a pair of speakers or components with 150 watts RMS each. In 3-channel mode, you can use the amp's front channels to drive a pair of speakers with 50 watts each, and bridge the rear channels to send 150 watts to a sub. Features - Max Power: 600W Variable High & Low Pass Filter Bass Boost RMS Power: ○ 50W x 4 (4Ohms) ○ 75W x 4 (2Ω) ○ 150W x 2 (Bridged) Speaker Level Input Signal Sensing Turn-On Specifications - Signal to Noise Ratio: 100dB (Reference: Rated Power into 4Ohms at 14.4V) Frequency Response: 20Hz-50kHz (+0dB, -3dB) Input Impedance: 10k ohm Speaker Impedance: 4Ω (2Ω to 8Ω allowable) Bridged Connection: 4Ω to 8Ω allowable Terminals - Battery & Ground: M6 Screw Type Terminal Block Speaker Output: M4 Screw Type Terminal Block