We specialize in hard to find items
All Categories
1" 110V Brass Electric Solenoid Valve 1 Inch Normally Closed NPT Valve for Water Gas Diesel Air Fuel Oil
Share Tweet
*Price and Stocks may change without prior notice
*Packaging of actual item may differ from photo shown
- Electrical items MAY be 110 volts.
- 7 Day Return Policy
- All products are genuine and original
- Cash On Delivery/Cash Upon Pickup Available
1" 110V Brass Electric Solenoid Valve 1 Inch Features
-
2 way solenoid valve, 1" NPT port, brass body, AC 110 volt, Orifice: 25mm, Model: 2W-250-25
-
Constructed of industrial grade brass and VITON seal which is corrosion resistant, more conducive for welding, optimal for higher temperature projects and corrosive chemicals and other fluids like gasoline, diesel fuel, oils
-
Working Pressure: Air - 110 psi / Water - 75 psi / Light Oil - 60 psi, Working temperature range: -5 ℃~85 ℃
-
Wide range of use in many fields: Irrigation controls (garden, farm,etc.), liquid controls ( pipeline, artificial river etc. and air controls ( lab, factory, etc.)
About 1" 110V Brass Electric Solenoid Valve 1 Inch
Descriptions: 25mm opening allows a high flow rate for applications that requir This valve is N/C (normally closed), meaning it is closed when power isn't supplied Can be used with co2, compressed air, diesel, gas, water, light oils, and many other substances Valve is not intended to be energized continuously for more than 8 hours. This can lead to burnout of the coil, and malfunctioning of the valve Solenoid Valve Installation Instructions Clean and rinse the impurities in the pipeline before installation;The thread should be wound with Teflon Tape. Be careful not to drop the debris into the pipeline to prevent blocking the solenoid valve. When installing, keep the arrow direction on the valve body consistent with the flow direction of the medium;If there is reverse pressure, a check valve shall be installed. In order to ensure and extend the service life of the solenoid valve, the installation should be horizontal, the coil is vertical up, not vertical or backward installation After the solenoid valve coil outlet wire (connector) is connected, it should be confirmed that whether the contact of electrical components should be firmly connected should not shake, looseness will cause the solenoid valve not to work. Solenoid valves that are out of service for a long time should be cleaned of impurity condensation before use. Solenoid valves are not suitable for fluids under the following conditions: A.Changing into a liquid by heating and into a solid by cooling; B.Viscosity greater than CST50;C.Fluid with impurities, impurities are easy to block the valve.
