We specialize in hard to find items
(1)
Treedix 5-12V ZVS Low Voltage Induction Heating Power Supply Module with Coil Power Supply Heating Power Supply Module
Share Tweet
*Price and Stocks may change without prior notice
*Packaging of actual item may differ from photo shown
- Electrical items MAY be 110 volts.
- 7 Day Return Policy
- All products are genuine and original
- Cash On Delivery/Cash Upon Pickup Available
Treedix 5-12V ZVS Low Voltage Induction Heating Features
-
ZVS heating Power Source module, with heating coil included. The heating coil can be soldered onto the PCB.
-
Input Voltage：DC 5V~12V(This voltage range is the voltage during operation, not the voltage when the power supply is unloaded).
-
The width of the object to be heated should be between 1/3 and 1/2 of the inner diameter of the heating coil, and it should not exceed 2/3.
-
Ensure all the components welding right, power line connected in the right way, then to set up an electric circuit.
-
The current / voltage is directly linked to what you're heating. Coil size: Length:7.5cm/ 2.95 inch ; Width: 2.8cm/ 1.10 inch
About Treedix 5-12V ZVS Low Voltage Induction Heating
Specification： Input Voltage：DC 5V~12V Max Power：120W PCB Size：55 x 37 x 1.6 mm Package Included: 1 x ZVS heating Power Source module 1 x heating coil Note: 1. When inductive heating, usually work for 5 minutes to power off cooling. Because the current is relatively large during induction heating, the coil heat is also relatively large. When heating, part of the heat generated by the heated object is transmitted to the heating coil. For a long time, the temperature of the heating coil is high. If the heating coil is connected to the terminal, the plastic part of the terminal will be melted. Therefore, when induction heating, it is best to solder the heating coil directly to the PCB 2. Only some types of materials can be effectively induction heated - mostly magnetic materials such as steel. Materials such as brass, copper and aluminum will be very difficult to heat. 3. A large capacitor placed in parallel with the supply voltage can help reduce the voltage/current drop that prevents the unit from starting. 4. This module should not be operating when no load, otherwise it might burn out the circuit. 5. You can check whether the blue LED indicator light up to see if the power is supplied or the module can functionally work. When the indicator is dim, maybe the power supply is insufficient, should use a higher power supply. Just make sure the power supply is within DC 5-12V. Remark: You can solder the heating coil on the board.
