3M DP-100-CLEAR Scotch-Weld Epoxy Adhesive, Clear, 1.7 oz Duo-Pak

Pay with

About 3M DP-100-CLEAR Scotch-Weld Epoxy

This is a 3M ScotchWeld Epoxy Adhesive DP100 Clear in the new cartridge design, and includes 1 of the new-design mixing nozzles. 3M ScotchWeld DP-100 3-5 Minute Extra-Fast Setting Clear Epoxy Adhesive is a fast set/cure multipurpose, two-component, room temperature clear Epoxy adhesive of good strength and toughness. It is an excellent bonder for Steel (ferrous and stainless), Aluminum, and many types of Plastics. Work Time: 3-5 minutes set Handling Strength: 15-20 minutes Full Cure Strength: 24 hours Color: Clear Viscosity: Thin Syrup (8,000 to 17,000 cps) Typical Uncured Physical Properties Note: The following technical information and data should be considered representative or typical only and should not be used for specification purposes. Viscosity1 Base 8,000-15,000 cps Accelerator 10,000-17,000 cps Color Clear/Lt. Amber Net Weight Base 9.5-9.9 Mix Ratio (B:A) Volume : 1 1 Worklife2 10 g mixed 5 minutes 5 minutes (Gel time3) Typical Cured Physical Properties Physical: Color Clear Shore D Hardness 80-85 Time to Handling Strength4 15-20 min. @ 23°C (73°F) Cure Time5 24-48 hours @ 23°C (73°F) Thermal: Wt. loss by Thermal 5% @ 307°C (585°F) Gravimetric Analysis6 Glass Transition Temp7 33°C (91°F) Thermal Conductivity9 0.107 @ 46°C (115°F) Electrical: Dielectric Strength 860 volts/mil 1100 volts/mil (ASTM D 149) Volume Resistivity 3.5 x 1012 ohm-cm 2.2 x 1014 ohm-cm Please Note: These cartridges are designed to work best with a 50ml cartridge Dispenser. It is strongly advise you use a 50ml Dispenser for this cartridge. This 3M cartridge will fit into any standard ‘Square-Back’ Dispenser. If you do not have one, please check out the “MixPac 50ml Dispenser” here on Amazon.