We specialize in hard to find items
All Categories
ElectroniCoat - Clear Waterproof Coating for Circuit Boards
Share Tweet
*Price and Stocks may change without prior notice
*Packaging of actual item may differ from photo shown
- Electrical items MAY be 110 volts.
- 7 Day Return Policy
- All products are genuine and original
- Cash On Delivery/Cash Upon Pickup Available
ElectroniCoat - Clear Waterproof Coating for Features
-
High dielectric, 4mil coating provides 300 volt dielectric strength
-
Waterproof, flexible and permanent
-
Works even when totally submerged in water
-
Dries to a clear transparent coating
-
For use on: electrical connections, phone and cable circuits, electrical systems, motor connections, circuit boards, outdoor light, security systems, electrical panels and general waterproofing
About ElectroniCoat - Clear Waterproof Coating For
Creates a waterproof, flexible, permanent rubber film that acts as a barrier against moisture, rust, and corrosion on electrical connections. Once applied, the area becomes impervious to humidity, salt, and contamination. Dries crystal clear and will not discolor or harm any surface. Formulated to protect components and surfaces from environmental damage. ElectroniCoat's elastomers and rubberized body form an extremely tight bond, inhibiting contamination growth, especially in humid conditions. Parts coated with ElectroniCoat are protected from water, even when completely submerged. Ideal for use as an insulator for electricity, the volume resistance makes it perfect for electrical terminals, protection against corrosion and moisture, and as an insulator in junction boxes and exterior wire connections. It is well-suited for encapsulating wire nuts and cable connectors exposed to the elements. One mil of ElectroniCoat equals 75 volts. For example, a 1/8” thick coating can withstand up to 9,500 volts, and a 1/16” coating can withstand up to 4,750 volts. Uses include electrical connections, phone and cable circuits, electrical systems, motor connections, circuit boards, outdoor lighting, security systems, electrical panels, and general waterproofing. Directions: Shake the container well before and during use. Due to the rubber content, the nozzle may occasionally sputter or momentarily clog. Continue to spray, and any clogging will clear after a few seconds. Peel away any accumulation from the nozzle tip. Ensure wires and terminals to be sealed are clean and dry. Spray on the electrical connection area and allow to dry for 15 minutes. Apply a second coat if greater thickness is required or needed. Note: Do not spray on running electrical motors or live wires. Disconnect all electrical equipment before using. Allow sufficient time to dry before reconnecting electrical equipment.
