Elliot Jonah DY Portable Car Truck Engine Heater Oil Pan Tank Heater 120W 110V Pad Heater Orange

Pay with

About Elliot Jonah DY Portable Car Truck Engine Heater

Portable Car Truck Engine Heater Oil Pan Tank Heater 120W 110V Pad Heater Orange Specification: Material: Alloy wire,Silicone rubber Color: Orange Product size: Heater size: length:13cm Width:9cm Wire length: 200cm Insulation material the highest resistance temperature: 300 degrees Power error: 8% Insulation resistance:≥5 MΠCompressive strength: 1500v/5s Resistance voltage: 6KV Power:110v 120w Package Included: 1 PC Heater Pad (not with plug) INSTALLATION INSTRUCTIONS FOR SILICONE HOT PAD HEATER: 1. CLEAN AND SAND RESERVOIR TO BARE METAL. REMOVE ALL DIRT, GREASE, OIL AND OTHER CONTAMINANTS USING A DEGREASING SOLVENT. DO NOT USE GASOLINE OR ACETONE. 2. IF HEATER IS TO BE INSTALLED ON A VEHICLE, TRY TO RUN THE ENGINE TO PRE-WARM THE OIL PAN. 3. PEEL OFF BACKING AND APPLY PAD TO RESERVOIR MAKING SURE THAT THERE ARE NO AIR POCKETS OR CREASES IN THE PAD. USE A ROLLER OR SPREADER TO REMOVE THEM. 4. SEAL THE EDGES OF THE HEATER WITH HIGH TEMPERATURE SILICONE TO INSURE PROPER PROTECTION TO THE EDGE OF THE HEATER. 5. SECURE THE CORD UP AND OUT OF THE WAY OF ANY OBSTRUCTIONS, MAKING SURE THAT IT DOES NOT HANG DOWN FROM THE PAN OR TOUCH ANY HOT OR MOVING NOTE: 1. Do not cut pad. 2. Do not use on batteries 3. This heater can only be used on a metal pan or tank with a smooth float surface.. It should never be installed on a plastic or poly container.