We specialize in hard to find items
All Categories
MakerFocus 15pcs TP4056 Charging Discharging Module Type C Interface with Battery Protection 18650 BMS 5V 1A 18650 Lithium Battery Charging Board
Share Tweet
*Price and Stocks may change without prior notice
*Packaging of actual item may differ from photo shown
- Electrical items MAY be 110 volts.
- 7 Day Return Policy
- All products are genuine and original
- Cash On Delivery/Cash Upon Pickup Available
MakerFocus 15pcs TP4056 Charging Discharging Module Features
-
Upgrade Version: The input has a Type C female connector, which can be directly input as a mobile phone charger to recharge the lithium battery; The input voltage wiring pad is also reserved, which can be very convenient for DIY
-
Usage: The +/- pads are the power inputs, access to 5V. B+ connects to the positive pole, B- connects to the negative pole, OUT+ and OUT- connects to the loads, such as connecting to the positive and negative pole of the mobile booster board or other loads
-
Application: TP4056 module can charge for single-cell lithium battery or multi-section parallelled lithium batteries, can be powered by USB ports; The module with USB port, can be directly input to do with rechargeable lithium battery as a phone charger
-
Note: When first accessing the battery, there may be no voltage output between OUT+/OUT-, at this time access to 5V charging can activate the protection circuit, the battery is disconnected from B+/B- and then connected again also need to be charged to activate the protection circuit. When using a mobile phone charger as input, the charger should be able to output 1A or above, otherwise it may not charge properly.
-
Attention: The charge should disconnect the load OUT terminal on the positive and negative can not be wrong, please according to specifications, otherwise it will damage directly
-
Reminder: Please check all the connections before charging, it will be damaged if the load OUT on the positive and negative with wrong polarity. If you do this the first time, please watch the video on Youtube before installation
About MakerFocus 15pcs TP4056 Charging Discharging Module
TP4056 battery charging board has protection function, battery can be charged and discharged at the same time Description: Input with Type C USB female socket You can directly use the mobile phone charger as the input to charge the lithium battery Retain the input voltage wiring soldering points, can be very convenient DIY Parameters: Input Voltage: 5V Charging Cut-off Voltage: 4.2V ±1% Large Charging Current: 1000mA Battery Over-discharge Protection Voltage: 2.5V Battery Overcurrent Protection Current: 3A Size: 2.6*1.7CM Usage: The first time you access the battery, there may be no voltage output between OUT+ and OUT-, then access the 5V voltage to charge a little to activate the protection circuit, the battery is disconnected from B+/B- and then connected again if you also need to charge a little to activate the protection circuit. When using a mobile phone charger as input, note that the charger should be able to output 1A or above, otherwise it may not be able to charge properly The Type C USB female connector and the +/- pads next to it are the power inputs, connect them to 5V, B+ to the positive terminal of the Li-ion battery, B- to the negative terminal of the Li-ion battery, OUT+ and OUT- to the loads, such as connecting to the positive and negative terminals of the mobile booster board, or other loads Connect the battery to B+/B-, insert the mobile phone charger into the USB female socket, the red light is on for charging, the blue light is on for full Package Content: 15 * TP4056 Charging Discharging Module
