Beckett 7505P GeniSys Cad Cell Oil Primary Control w/ 15 sec Pre-Purge & 15 sec Post-Purge (Replaces R7184P Relay Controls)

Pay with

Beckett 7505P GeniSys Cad Cell Oil Primary Control Features

• Lockout Timing: 15 Seconds

• Voltage: 120v

• Frequency: 60 Hz

• Storage Temperature: -40 to 150F

About Beckett 7505P GeniSys Cad Cell Oil Primary Control

7505P Advanced Burner Control is the Beckett direct replacement for R7184B controls on Beckett burners. This version has 15 seconds Pre-purge and 15 seconds post-purge. Other versions available see Models and Cross Reference Guide in Manuals section.The 7505P can be programed with pre-purge and post-purge and cycle history read using the GeniSys Contractor tool.The Beckett GeniSys„ Advanced Burner Control is a 120 VAC primary safety control for residential and light commercial oil burners used in boiler, furnace, and water heater applications. The GeniSys„ is used with a suitable cad cell flame sensor to control the oil burner motor, igniter, and optional solenoid valve. It has 24 VAC thermostat terminals (if applicable) compatible with both mechanical and many power stealing thermostats. It can provide interrupted or intermittent duty ignition, and it has a 15 second lockout time.Water ResistantThermostat and boiler control compatibleThree status lights for system monitoring and diagnosticsWelded relay protection with redundant motor relaysLimited reset and limited recycleTechnician Pump Prime mode5-Year Warranty7505A0000 replaces Honeywell R8184GTwo communication ports for adding alarm contacts and programming tool.Lockout time (TFI) “ 15 secondsPre-purge “ 15 secondsPost-purge “ 15 secondsCustomizable pre-time and post-time using Contractor Tool 52082USpecifications: Lockout Timing: 15 SecondsVoltage: 120vFrequency: 60 HzStorage Temperature: -40 to 150F