YOGOTEU for 2.8-6V 30-1500MA 1.5A LED Driver PWM Control Board Module Adjustable Transmitter Circuit Board Converter Power Supply Module Drive Connector Electronic Chip Amplifier PCB Charger

Pay with

YOGOTEU for 2.8-6V 30-1500MA 1.5A LED Driver PWM Features

• LD06AJSA / B is a current regulation integrated circuit operating from an input voltage of 2.8 V to 6 V, the constant output current can be set to 1.5A with an external resistor. the LD06AJSA / B consists of reference voltage, amplifier, current

• The on-chip power transistor and current block significantly reduce the number of external components, which makes the LD06AJSA / B ideal for LED driver.

• When the pin is the input voltage is greater than 2.8 V, and is higher than the direct voltage LED the required voltage drop, LD06AJSA / B normally operates to provide constant current from the PULLOBEE.

• The LD06AJSA / B adopts temperature regulation instead of temperature protection function, the temperature regulation can cause the LEVOU to be switched on continuously in case of temperature fall.

• When the LD06AJSA / B temperature junction reaches about 135 ° C, the internal temperature setting of reduces the current so that the temperature of the LED junction will not rise further. this feature allows users to maximize the use of the power handling ability of the chip, do not worry about the chip overheating and damage to the chip external components.

About YOGOTEU For 2.8-6V 30-1500MA 1.5A LED Driver PWM

For 2.8-6V 30-1500MA 1.5A LED Driver PWM Control Board Module Adjustable Description: LD06AJSA / B is a current regulation integrated circuit operating from an input voltage of 2.8 V to 6 V, the constant output current can be set to 1.5A with an external resistor. the LD06AJSA / B consists of reference voltage, amplifier, current The on-chip power transistor and current block significantly reduce the number of external components, which makes the LD06AJSA / B for ideal for LED driver.When the pin is the input voltage is greater than 2.8 V, and is higher than the direct voltage LED the required voltage drop, LD06AJSA / B normally operates to provide constant current from the PULLOBEE. The LD06AJSA / B adopts temperature regulation instead of temperature for protection function, the temperature regulation can cause the LEVOU to be switched on continuously in for case of temperature fall. When the LD06AJSA / B temperature junction reaches about 135 C, the internal temperature setting of reduces the current so that the temperature of the LED junction will not rise further. this feature allows users to maximize the use of the power handling ability of the chip, do not worry about the chip overheating and damage to the chip external components.The LD06AJSA / B also has the function of allowing the chip, which can the whole chip to limit the shutdown current consumption within 1uA.The LD06AJSA / B also adopts the current overload for protection block. When the current LED 1.9A approaches (Typical), the on the current block for protection starts the function to prevent the current LED from increasing.Application 1: Wiring according to the following figure, use a suitable screwdriver carefully and slowly rotate the adjustable resistance.Application 2: Adjust the adjustable resistance to 0 ohms maximize the current according to