Chimera Swing Arm/Axle Race Bolt for Grom 125 (2014-2020) - Extended Length 345mm

Pay with

Chimera Swing Arm/Axle Race Bolt for Grom 125 Features

• Chimera Engineering Race Bolt for the rear swingarm (320mm). The stock swing arm bolt requires you to slide the whole bolt out in order to change or service the rear-set (on one side).

• The Chimera Race Bolt has two nuts on each end, which allows you to service or remove EITHER side of your rear set without the need to remove the bolt.

• Designed specifically for racers, stunters, and those who want an easier way to service or change their rear set without having to fight and realign the swingarm.

• Has pre-drilled holes, ready for safety wires and/or hitch pins (hairpin clips).

• This race bolt can also be used as a replacement rear axle (320mm). For those that need a longer axle, you can use the longer version (345mm). Great for those with stunt pegs or paddock stand spools.

About Chimera Swing Arm/Axle Race Bolt For Grom 125

Chimera Engineering Race Bolt for the rear swing arm allows you to quickly and easily change either side of the rear-sets by simply removing the nuts. The stock swing arm bolt is only threaded on one side, which requires you to completely remove the bolt out to remove the rear set on one side. This will most likely drop and misaligned the swing arm to the frame. The Chimera Race Bolt will prevent all of that from happening. Perfect for those who track or stunt their Grom's! Will fit the swingarm all years Honda Grom 125 2014+ Diameter: 12mm (0.47" ~ 1/2") Overall Length: 320mm (12-5/8") Minimum inside length with nuts threaded on = 295.28mm (11-5/8") from the outer nuts Non-threaded center area length = 260mm (10-3/16") Machined from stainless steel Axle Nuts (2pc) included Has pre-drilled holes for safety wires or hitch pins (hairpin clip) Will work with nearly every common rear-sets on the market (OEM Stock, Driven Racing, Woodcraft, Spyker, etc) Simple installation! (Leave the bike on the kickstand, remove the nut from stock swing arm bolt. Using a rubber mallet, tap/push/drive the Chimera Race Bolt through) NOTE: For those that want approximately 1" longer rear axle for the Grom we offer the 345mm (13-5/8") version. Diameter: 12mm (0.47" ~ 1/2") Overall Length: 345mm (13-5/8") Minimum inside length with nuts threaded on = 295.28mm (11-5/8") from the outer nuts Non-threaded center area length = 280mm (11-1/8")