Pocono Metal Craft Rear Trail Arm Skid Driver LH Center Frame Rust Repair Jeep Wrangler TJs 1997-2002

Pay with

About Pocono Metal Craft Rear Trail Arm Skid Driver LH

Driver side repair pieces for Jeep Wrangler years 1997-2002. This set includes the trail arm repair piece and the center skid plate repair piece. Constructed of 10 gauge hot rolled high carbon steel which is thicker than your existing frame and thicker than the other sellers. Trail arm: This piece will fix the area in front of the rear driver's side axle where rot typically occurs. On your original frame there is a factory drilled access hole, which allows debris and water to enter and creat rust over time. Our design includes a drain hole to prevent this from happening again. Piece includes both upper and lower control arm mounts. Lower control arm bolt is included. Measures approximately 22" end to end. You will need to remove the bottom 2/3 of the frame rail, grind smooth, slide the piece over the remaining upper 1/3, then weld. Skid plate: This piece is a full length repair piece that completely repairs the area in front of and behind the skid plate. This piece gets attached to the frame and the transfer case and transmission get bolted to it. Hardware is included. Measures approximately 43 1/2" end to end. These are weld on pieces. Moderate welding skills required. You will need to cut out the lower 2/3 of your frame and sandwich the repair piece over the remaining upper 1/3. Align bolt holes then weld around the perimeter. These items will be delivered bare steel and deburred.