TFCFL Jewelry Spot Welder,Electric Sparking Welding Machine Jewelry Tool with Foot Pedal for Gold,Silver 110V 800W 0.5-80A (Small)

Pay with

TFCFL Jewelry Spot Welder,Electric Sparking Welding Features

• ♥【Product Parameter】Power supply: AC110V,Power: 800W,Welding current: 0.5-80A continuously adjustable (pulse ignition),Welding range: 0.2-1.3mm.Adjustable pulse spot welding machine

• ♥【Advantage and Features】Welding can change the output pulse current according to the size of the workpiece, the size of the solder joints, and the process requirements

• ♥【Warm Tips】If the place where the welder is placed is wet or not used for a long time, it will be damp. If it is found that the above phenomenon should be dried before use, the machine should be well grounded.

• ♥ 【Wide Applications】It can weld gold, silver, platinum, palladium, stainless steel, titanium, all of which are weak arc welding metals can be welded.Skilled can also weld small parts inside dental steel wire thermocouple clock, etc

• ♥【Customer Service】If you have any questions or quality issue,please feel free to contact us.

About TFCFL Jewelry Spot Welder,Electric Sparking Welding

Specification: Power supply: AC110V Power: 800W Welding current: 0.5-80A continuously adjustable (pulse ignition) Welding range: 0.2-1.3mm Instructions: 1. Before using the welder, first check if the power supply meets the operating voltage. 2. Connect the welder output wire to the screw of the corresponding output stage (tighten the nut when the output wire is connected to the output pole) 3. When working, clamp the workpiece with the clip on the output black line, close to the tungsten needle (depending on the size and shape of the workpiece, generally the distance between the tungsten needle and the workpiece is between 0.5-1 mm). After the welding position is fixed, Jog the foot switch, and a high-temperature arc between the workpiece and the tungsten needle instantly welds the workpiece. 4. The discharge end of the tungsten needle must be kept sharp before use and during use to maintain a good discharge state. 5. Welding can change the output pulse current according to the size of the workpiece, the size of the solder joints, and the process requirements (the machine can weld 0.5-1.5MM). When the potentiometer is rotated clockwise, the output pulse current increases, whereas the output pulse current decreases. Precautions: If the place where the welder is placed is wet or not used for a long time, it will be damp. If it is found that the above phenomenon should be dried before use, the machine should be well grounded. Please pay attention to safety when using. Standard Accessories: One host power cable Foot switch Workpiece clip Tungsten needle Torch needle holder Instruction manual