BBMI Road Flares, Led Road Flares Emergency Lights, Safety Halo Road Flares Kit, Warning Flashing Road Flares Sticks - 3 Packs

Pay with

BBMI Road Flares, Led Road Flares Emergency Features

• SOLID CONSTRUCTION: the product shell is made of anti manufacturing material, and the shell is made of high-strength transparent engineering plastic PC and TPE elastic plastic by injection molding.

• NINE MODES: 12 red LEDs for flash and 3 white LEDs for illumination.There are nine optional lighting modes, namely Double Pulse, Single Pulse, Short Single Pulse, Rotating Beacon, Alternating Flash, SOS, Steady Full Beam, Steady Low Beam, White LED Work Light, which are fully functional and have remarkable effect.

• HIGHLY VISIBILE: These extremely bright red flashing emergency roadside discs are visible from up to one mile away at night. The LED beacon warns approaching vehicles on the road to slow down and approach safely. Helps emergency responders see you on the side of the road.

• EASY MOUNTING WITH MAGNETIC BASE AND FOLD OUT HOOK: Attach the flares to the sides or back of your car or truck. The fold-out hook and flashlight mode provides hands-free use while working under the hood or changing a tire.

• APPLICATION SCOPE: It can be used for traffic control, as a warning light, as a rescue beacon, and in any other emergency situations. Also as a great tools for outdoor activities such as camping, hiking, boating, cycling, etc.

About BBMI Road Flares, Led Road Flares Emergency

Product descriptionMaterials:High quality ABS, Engineering grade plastic, Magnetic diskLight Color: redSize: 95mm (3.75") diameter x 35mm (1.37")tallHow to use:To Install Batteries (3 AAA) Required. A small Phillips screwdriver is needed.1.Turn your LED Flare over to see the two small screws on the back.2.Position the top curve of the hanger directly to the top (or facing 180 degrees away from you).3.Remove the two screws.4.Looking at the flare as if it was a clock, the small indentation at the top of the hanger should be at the 12 o’clock position.5.You’ll see two small tabs at the 10 o’clock position and at the 2 o’clock position. These are to assist in removing the back plate of the flare. No prying or other tools are needed. The back fits snugly because the flare housing is sealed in order to make them waterproof. Now you can pull the rear cover off with just your fingers by applying pressure to the two small tabs.6.The polarity of the batteries is marked inside the battery compartment. For ease and quick installation, just remember that the middle battery will have the negative (-) end towards the top. The batteries on each side will have the positive (+) end to the top of the flare.7.Now press the on/off button to make sure that the LED flare is operational.8.Replace the rear cover, making sure that the top of the curved hook is towards the top of the flare  (12 o’clock position), and directly behind of the LED work light on the front.9.Tighten the two screws evenly, but do not over tighten.LED Safety Flare ModesPush the On/Off button on front to turn the LED flares on.Push On/Off button to scroll through the nine light modes.You can turn the flares off by pressing and holding the On/Off button for three seconds. You can also turn it off by scrolling through all nine modes.