PRV AUDIO 12 Inch Woofer 12W1600, 1600 Watts, 4 in Voice Coil, 8 Ohm, Pro Audio Speaker (Single)

Pay with

PRV AUDIO 12 Inch Woofer 12W1600, 1600 Watts, 4 in Features

• Ventilated voice coil gap reduces power compression and 4″ split copper voice coil wound on fiberglass former for hi-temp performance, 8 ohm

• 1600 Watts of program power rating makes high acoustical output

• 10.5 mm Xmax, 36 mm peak-to-peak excursion before damage

• Made with a weather-resistant paper cone and dust cap

• High BL factor and Xmax for outstanding Low output

About PRV AUDIO 12 Inch Woofer 12W1600, 1600 Watts, 4 In

PRV AUDIO 12" WOOFER LOUDSPEAKER Nominal Impedance: 8Ω Ohms Rated Power Handling: 800 Watts Program Power: 1600 Watts Sensitivity (1W/1m): 94 dB Resonance Frequency (Fs): 45.48 Hz Frequency Range at -10 dB: 50 - 2,500 Hz Recommended Hi-Pass X-Over: 60 Hz Xmax: 10.50 mm Voice Coil Diameter: 4" Magnet Material: Ferrite Frame Material: Die Cast Aluminum Weight: 24. 22 Lbs Mounting Depth: 5.51" (140 mm) It features a special 4″ split copper wire voice coil wound on a fiberglass former using proprietary high-temperature adhesives. An optimized ceramic ferrite magnet assembly will guarantee a very good low dynamic range with a very low distortion figure. This professional low-frequency driver is especially recommended for compact vented enclosures, in which it will deliver solid, deep bass output. Designed to make tremendous amounts of bass, it can be used in a small vented or sealed cabinet. The shallow 5.51″ mounting depth and high EBP makes it ideal for compact folded horn enclosures. The specially designed rigid cast aluminum frame features side forced cooling system openings allowing airflow to cool the voice coil to handle up to 800 watts RMS without issue. Spring-loaded push terminals make installation a snap while offering a secure connection to your speaker wires. A 4″ spit copper voice coil was designed that is wound inside-outside on a fiberglass former and features a generous 27.5 mm winding length for extended Xmax and less distortion. The cone, constructed of thick paper for natural response, includes glass fiber reinforcement and uses a ribbed design offering additional structural support. Supporting the cone is a double heavy spider and triple roll treated cloth surround, designed for high excursion applications to handle short bursts of excessive power without damage.