VEVOR Laser Power Supply 50W Co2 Laser Engraver Power Supply 110V/220V Laser Tube Power Supply for Laser Cutter Engraving Machine(50W)

Pay with

VEVOR Laser Power Supply 50W Co2 Laser Engraver Features

• High Efficiency: This power supply uses a zero-current half-bridge soft switching circuit, which makes the power supply highly efficient and fast in response.

• Simple Port Control: Suitable for high and low-level signals. Use the TTL level to control the laser start and stop. At the same time, a protection switch is added to detect whether there is water or ventilation outside.

• Laser Power Adjustment: The laser power adjustment can input 0 to 5V analog signals, can also input PWM signals.

• Open Circuit Protection: The power supply has an open circuit protection function, which can avoid damage to the laser power supply due to the burst of the laser tube.

• Factory Aging Test: Each power supply will be subjected to a high temperature 60 ° C 12-hour aging test under full load, and the power supply test will be started and stopped 500 times in 7 seconds.

About VEVOR Laser Power Supply 50W Co2 Laser Engraver

Laser Power Supply The CO2 laser power supply is small in size, light in weight, easy to operate, and has good matching performance with the laser tube, which can be directly connected to the laser tube. Fast response speed, good effect, high performance, high cutting power, and can extend the life of the laser tube. High PerformanceFast response speed, good effect, high performance, high cutting power, and it can extend the life of the laser tube. Easy ControlLaser power supply machine start and stop can be easily controlled by TTL level. Simple Laser Power ControlTwo methods to adjust laser power: Input 0V to 5V analog sighnal, can also input PWN signal. Mark ClearlyEach data is clearly marked for your convenience.Power detection instructions: When the power supply is in standby state, press the test switch. if the L light is on and the P light is on, laser tube does not output laser, the laser tube is broken. If the laser tube outputs laser, the laser power is normal; if the LASER lamp is off, the laser power is bad. Protection FunctionOpen circuit protection function, it can be used to detect the presence or absence of waterway, protect the laser; It can better protect the laser power and prolong the service life. Good CompatibilityCo2 laser engraver power supply is suitable for a variety of CO2 laser tubes. Specification: Input voltage: AC110V / AC220V Maximum output voltage: 22KV Maximum output current: 22mA Efficiency: 91% Response speed: ≤1ms Cooling method: fan cooling Gross Weight: 1.2kg/2.64lbs Package Size: 23x23x13cm/9x9x5.11inch Package Content: 1 x high voltage connector 1 x laser power supply