ABN Wheel Bearing Puller Kit Hub Removal Tool, Wheel Bearing Tool - Independent Suspension Roll Ball Bearing FWD RWD AWD

Pay with

ABN Wheel Bearing Puller Kit Hub Removal Features

• [No More Hammer or Shop Press]: The ABN Master Wheel Bearing Removal Tool and Wheel Hub Puller Tool Kit allows you to remove and install wheel hub and bearing assemblies as well as inner bearings without the use of a less safe hammer or shop press

• [Fits Your Vehicle]: Universal for front, rear, and all-wheel drive vehicles with independent suspension and pressed roller-ball bearings; Compatible with rear-wheel drive Mercedes, Porsche, BMW, most European vehicles; Compatible with front-wheel drive Volkswagen, Audi, most Asian vehicles

• [Use on Seized-Up Assemblies]: Self-centering mechanism and thrust bearing design; Use the round plate that corresponds to the diameter of your bearing, turn the long screw that extends through the bore of the hub, allow the plate to pull out the bearing, then reverse the tool to press in a new bearing

• [Perfect Sizes]: Universal set includes 21 pieces that have A through U permanently printed labels; Pusher washer disk driver sizes from 2.1 inches with 1.1-inch diameter inner step (5.3cm with 2.8cm step) to 3.2 inches with 1.7-inch diameter inner step (8.1cm with 4.3cm step)

• [Contents]: Wheel hub and bearing puller set and installation kit includes a remover tool, adapter shoes, pusher washers, receiver sleeves, nut-bolt, bearing, and plastic blow-molded carrying case; All pieces in this wheel bearing kit are pre-oiled for maximum longevity

About ABN Wheel Bearing Puller Kit Hub Removal

Remove and replace wheel hub and bearing assemblies as well as internal wheel bearings without the use of hammers or shop presses when you use the ABN Bearing and Wheel Hub Removal Tool Set. It works with most makes and models of FWD, RWD, and AWD American, European, and Asian vehicles with pressed hubs or bearings. This wheel hub bearing removal tool kit includes the hard-to-find sizes for German cars. Even if the assembly is seized up, the self-centering mechanism and thrust bearing design reduces effort for easier use and preservation of pressure screw. Use on hubs with removable axle and backside hub and bearing access. Insert round plate that corresponds to the diameter of your bearing, turn long screw, allow plate to pull out bearing, then reverse tool to press in new bearing. Warning: This product can expose you to chemicals which is [are] known to the State of California to cause cancer and birth defects or other reproductive harm.