We specialize in hard to find items
All Categories
ABN Professional Brake Line Flaring Tool Kit, 45 Degrees - Single, Bubble, Double Flare Tool Kit for Steel, Copper Tube
Share Tweet
*Price and Stocks may change without prior notice
*Packaging of actual item may differ from photo shown
- Electrical items MAY be 110 volts.
- 7 Day Return Policy
- All products are genuine and original
ABN Professional Brake Line Flaring Tool Kit, 45 Features
-
[Get a Leakproof Connection]: When building car brake lines, the ABN Professional Brake Flaring Tool Kit adds a flare (makes tubing wider) to brake line end for a leak-free connection without hours of hand cramping or twisting exercises
-
[Fits Your Application]: 45-degree set creates single, bubble, and double flares on steel, stainless steel, and soft metal (copper, aluminum) brake lines, transmission cooler lines, and fuel lines; For 3/16-inch (4.75mm), 1/4-inch (6.35mm), 5/16-inch (8mm), and 3/8-inch tubing
-
[Use Your Vise]: Use on a bench-mounted vise in your workshop or on a hitch-mounted vise in the field (not intended for use under car); 6-inch (15.2 cm) T-handle screw clamp holds die and tube in place so you can create flares quickly and easily
-
[Durability You Need]: Deburred square pipe end with outer edge chamfered approximately 0.25 x 45 degrees; Each die block is 1.7 inches (4.3 cm) long; Approximate 1.5-inch (3.8 cm) actual clamping surface [we recommend only placing bends in the last 2.5 inches (6.4 cm) of tube after flared]
-
[Package Contents]: Brake line flare kit includes (1) brake line flare tool with T-handle and 11-inch lever with 5-inch texturized rubber sleeve (27.9x12.7 cm), (4) end dies, (1) instruction manual, and (1) 14.1 x 6.1 x 3.5 inch (35.8x15.5x8.9 cm) plastic blow-molded carrying case
About ABN Professional Brake Line Flaring Tool Kit, 45
Forget cheap tools that refuse to hold lines in place and make crooked flares. Instead of dreading your project, the ABN Flaring Kit Brake Line Brake Flare Tool Kit makes the job simple and fast. The line will not crush or slip when creating single, bubble, or double flares on 4 different sizes of softer metal tubing. If you bend lines and cut length for precise fit, allow enough straight brake line between line end and bend start to accommodate combined length of forming die blocks and intended brake fitting (add lengths together for minimum amount of straight line needed). Each die block is 1.7 inches (4.3 cm) long, and clamping surface is approximately 1.5 inches (3.8 cm). We recommend applying anti-seize (not included) on dies between uses for continued smooth and consistent operation. WARNING: This product can expose you to chemicals which is [are] known to the State of California to cause cancer and birth defects or other reproductive harm. For more information go to www.P65Warnings.ca.gov.
