We specialize in hard to find items
(1)
MOTOPOWER MP00207 6V and 12V 4AMP Automatic Smart Battery Charger, Battery Maintainer, Battery Desulfator with Force Charging Recondition Mode
Share Tweet
*Price and Stocks may change without prior notice
*Packaging of actual item may differ from photo shown
- Electrical items MAY be 110 volts.
- 7 Day Return Policy
- All products are genuine and original
- Cash On Delivery/Cash Upon Pickup Available
MOTOPOWER MP00207 6V and 12V 4AMP Automatic Smart Features
-
An intelligent battery charger and maintainer for all types of 6V and 12V lead-acid batteries, including Conventional Flooded (wet), Factory Activated Maintenance Free (MF/FA), Absorbed Glass Mat Maintenance Free (AGM), and Gel (Gel Electrolyte) type batteries. Input Voltage: 100-120V AC
-
FULLY AUTOMATIC - Voltage Auto Detection for 6V or 12V batteries - Dead battery detection and warning - Plug and go for charging and maintaining. The microprocessor controlled program will monitor the whole charging progress and automatically stop when the battery is fully charged. Then it will monitor the battery voltage and maintain the battery with a float charging current.
-
7 CHARGING STAGES & Repair Mode - Diagnosis, Soft Start, Bulk Charge, Absorption, Float, Maintenance and Recovery.Two charging rates (2Amp or 4Amp) can be selected to charge 12V batteries in different capacities. 2 amp charge rate for 6v battery. Repair mode for sulfated batteries.
-
SAFETY ENSURED - Advanced micro technology ensure the safety against overcharge, short circuit and reverse palarity. Spark free technology.
-
LED INDICATION & SAE QUICK CONNECTION - Easy to read LED lights indicate power on, 6v or 12v mode, 2 amp or 4 amp charge rate, and battery charge status.Includes SAE quick disconnect Battery Terminal and Alligator Clip leads for ease of use.
About MOTOPOWER MP00207 6V And 12V 4AMP Automatic Smart
MOTOPOWER 6V/12V 4AMP Fully Automatic Smart Battery Charger / Maintainer - Premium Intelligent Charger Series The MOTOPOWER MP00207 Automatic Battery Charger/Maintainer is perfect for those wanting to charge and maintain their 6v or 12v lead acid battery. Charging Stages: *Diagnosis: Checks for proper battery connection (polarity) and for internal battery damage causing a short. Detects the battery voltage (6V or12V). Tests the battery to determine whether it is good or dead. *Bulk Charge: For 6V battery: Charges with constant current of 2A. For 12V battery: Charges with constant current of 2A or 4A (Determined by user). *Absorption: Using a constant high current for extended periods of time increases the risk of damaging the battery. To help eliminate the risk, a constant low charging current (output) is given until the battery is fully charged, then the output is turned off. *Maintenance: The charger monitors the battery voltage. If the battery voltage falls below 12.8V±0.2V for a 12V battery or 6.2V ±0.2V for 6V battery, the charger will restart output to charge the battery at about 1A current until fully charged then the output is turned off. The maintenance charging cycle is repeated to keep the battery in good condition when it is not in use and enables the charger to be left connected indefinitely. *Recovery: Use the Recovery Mode for 12V batteries with voltage lower than 8V (the battery should not be completely dead). Recovery Mode charges at a constant 1.5A (rated) low charging current (output) to recover the battery. The recovery process terminates when the voltage reaches 10.5V ± 0.25V, and then it switches over to regular charging mode. NOTE: NEVER ATTEMPT TO CHARGE A DEAD BATTERY IN CASE OF DANGER!!!
