All Categories
Get it between 2025-01-20 to 2025-01-27. Additional 3 business days for provincial shipping.
The Thermopile is a Replacement of Fireplace Pilot Burner Assemnly Parts with Internal resistance (25°C) around 4000 mΩ and heating voltage above 750mV normally installed on plilot assembly used for fireplaces, frying, heating appliance
It will needs about 60 seconds (2 minutes ) to heat up to the 750mV and the flame should be heat the middle of the head sensor, So you may need time to waiting the valve start work.
Normal working temperature 700-750°C. Replacement of Heatilator Heat n Glo 24" Lead Thermopile, Fits Empire DV210, DV215, GWT25, GWT35, and GWT50 Models Replacement of PITCO 60125501 Model
The Repalcement of heatilator thermopile 100% Tested, Quality Assured. Suitable For American Deep Fryer Thermostat Control Valve Pilots Light
750 Millivolt Replacement Thermopile Generators have long been used in self-powered heaters and hot water equipment.
750 Millivolt Replacement Thermopile Generators have long been used in self-powered heaters and hot water equipment. It has been proven in millions of appliances as the contractor's preferred thermopile and are found in many of today's self powered gas fireplaces. Working Instructions: 1). Keep the thermopile heated in the 1/3 of the head location, Don't heat the back place to heater brass sleeve. 2). Because of High Resistance inside, The thermopile need around 1-2 minutes to be heated and increase to at least 750mV ( our reset voltage is around 800-900mV) 3) Do not take it off untill you heated it around 2 minutes 4) Do not bend the fireplace thermopile too hard on the crimped part and inside wires or it may cause short circuit and low voltage problem 5) If any problem, please contact us for customer service.