We specialize in hard to find items
(1)
20-pin Direct Wire Harness for Pioneer Headunits (Compatible with Subaru 2007-2015 and Nissan 2008-up Vehicles)
Share Tweet
*Price and Stocks may change without prior notice
*Packaging of actual item may differ from photo shown
- Electrical items MAY be 110 volts.
- 7 Day Return Policy
- All products are genuine and original
- Cash On Delivery/Cash Upon Pickup Available
20-pin Direct Wire Harness for Pioneer Headunits Features
-
Plug and play installation of a Pioneer double din car stereo (or single din radio) using the factory wiring. ONLY FITS A PIONEER RADIO. (Metra 70-7552 type connector wired to the Pioneer connector)
-
Reverse and E-brake signals are provided from the Pioneer connector. +12v switched (Red) and Ground (Black) connections are also provided for a steering wheel control interface or other +12v device
-
Compatible with 2007-2019 Pathfinder, 2007-2020 Frontier, 2008-2020 Altima, 2009-2020 Murano, 2011-2019 Rogue, 2009-2014 Non-Navigation Subaru Vehicles
-
Includes pins to connect a steering wheel control interface module. (Subaru Labels these Pins 4,13,14) (Nissan Labels these Pins 6,15,16)
-
This stereo installation kit is perfect for a Nissan Rogue car stereo if you are installing a Pioneer double din stereo radio or navigation system. Antenna adapter is sold separately
About 20-pin Direct Wire Harness For Pioneer Headunits
This adapter is used to install an aftermarket Pioneer Multimedia/Navigation Receiver in a 2007-2015 Subaru or 2008-2018 Nissan. Adapter includes pins to connect a steering wheel control interface module. (Pins 4,13,14)* and includes the Vehicle Speed Sensor signal wire. In addition, dedicated ground and +12 Volt Accessory wires are provided to power a steering wheel control interface module. **Pin 14 is grounded in the harness for the convenience of the installer. If this connection is not desired, cut the wire that connects between pin 14 and pin 10. Wires are either standard color coded or labeled for a simplified installation. Ground Wire Note: The ground wire found in the wiring harness is only for select vehicles only. Confirm that your vehicle's wiring harness has a corresponding ground wire. If no wire is present, cut the ground wire from the vehicle side of the adapter and connect the ground wires for the Pioneer and the Steering wheel control interface module to the vehicle's metal chassis.
