DGT MC-W1 1500mAh, 4-12v Rechargeable Tattoo Machine Battery RCA CONNECTOR build inJump start mode (Black)

Pay with

DGT MC-W1 1500mAh, 4-12v Rechargeable Tattoo Features

• The MC-W1 Rechargeable Tattoo Machine Battery RCA CONNECTOR build inJump start mode,Voltage Output: 4, 5 6, 7, 8 ,9, 11,12V, .Charging Voltage DC5V/1A, Input: TYPE-C

• Battery Capacity: 1500MAH, 4.Dual charge and discharge protection (Battery built-in over-surge protection, control board with short circuit over-surge over-discharge protection more safe.)

• Press power button for 2 seconds to turn on machine, Press up/down button to change the voltage, voltage goes in a cycle from: 4V-12V, Pass the up/down button for 3 seconds for the jump start (H) (L) seting

• Once machine is turned on, there will be a quick jump start at 10V, after 0.2 seconds machine will automatically resume to the last used voltage

• This product does not allow charging and running the machine at the same time, If short-circuit protection occurs during use, just plug into the charger and it will activate automatically

About DGT MC-W1 1500mAh, 4-12v Rechargeable Tattoo

The MC-W1 Rechargeable Tattoo Machine Battery RCA CONNECTOR build inJump start mode and offers voltage outputs of 4V,5V6V, 7V, 8V, 9V, and 11V, 12V It charges via a DC5V/1A input using a TYPE-C port and has a 1500mAh battery. The device includes dual charge and discharge protection, with built-in over-surge protection and a control board that safeguards against short circuits, over-surges, and over-discharges. To operate, press the power button for 2 seconds to turn on the machine, and use the up/down buttons to adjust the voltage in a cycle from 4V to 12V. A 3-second press of the up/down button initiates a jump start. Upon activation, the machine quickly starts at 10V, then reverts to the last used voltage after 0.2 seconds. In sleep mode, the battery display appears 2 seconds after pressing the power button, with light indicators showing the remaining battery percentage (20%-100%). Press the power button again to resume voltage adjustment. During charging, the light indicator flashes and turns solid when charging is complete, entering "protection" mode. The battery, with a capacity of 1500mAh, charges fully in approximately 3 hours, providing up to 8 hours of work time at voltages below 8V. Designed primarily for rotary tattoo machines, the MC-W1 should not be used with coil machines and does not support simultaneous charging and operation. In case of short-circuit protection, simply plug the device into the charger to reactivate it.