We specialize in hard to find items
All Categories
Master Magnetics ZG10A-Ax50BX Flexible Magnet Strip with Adhesive Back, 1/16" Thick, 1/2" Wide, 50' (1 Roll)
Share Tweet
*Price and Stocks may change without prior notice
*Packaging of actual item may differ from photo shown
- Electrical items MAY be 110 volts.
- 7 Day Return Policy
- All products are genuine and original
- Cash On Delivery/Cash Upon Pickup Available
Master Magnetics ZG10A-Ax50BX Flexible Magnet Strip Features
-
Magnet holds on one side only and is rated at up to 6 pounds perpendicular pull per linear foot, about 40% less pounds pull on vertical surface against sliding force, and less on painted steel
-
Magnet designed to hold on contact with flat, smooth ferrous steel, without a layer of material between magnet and steel not to other magnets. Minimum recommended length for magnet is 2"
-
Indoor/outdoor adhesive is pressure-activated, permanent, acrylic type, covered by peel-off liner with initial tack and minimum of 24 hour cure time requirement
-
Adhesive bonds to clean, smooth and uniform surfaces made of paper, wood, stainless steel, painted steel, aluminum, glass, and rigid plastics. For best results see full product description
-
Magnet withstands temperatures from 0-150 degrees Fahrenheit. Made in USA
About Master Magnetics ZG10A-Ax50BX Flexible Magnet Strip
Perfect for making flat lightweight items magnetic. Magnet requires direct and full contact with steel for maximum hold, therefore it is best to make sure that magnet is flat. Magnet & adhesive work best when applied at above 60 degrees Fahrenheit or 15.56 degree Celsius. For best results: 1)Allow magnet to reach room temperature then cut magnet with heavy duty scissors or hobby knife. 2)Apply magnet's dark gray side to large metal surface for several hours to flatten curl. Do not roll magnet strip in opposite direction to remove curl. 3)Clean applicable surface for adhesive with isopropyl alcohol and allow to dry. 4)Peel back liner from the adhesive and place item on adhesive. 5)Apply adhesive to surface with firm pressure 6)Allow adhesive to cure for a minimum of 24 hours or 72 hours to reach maximum bond with surface.
