We specialize in hard to find items
All Categories
Alightings LED Connector 5 Pin for 12mm RGBW Non-Waterproof LED Strip Lights- Strip to Wire Quick Connection, 20 - 18 AWG Wire No Stripping
Share Tweet
of brand new stock?
or
Need this item ASAP?
Check if this is available on Amazon
or available in other sites
Send us the link so we can buy for you
Alightings LED Connector 5 Pin for 12mm RGBW Features
-
Alightings rgbw connector suitable for 5 pin 12mm Non-Waterproof LED strip lights, One end for 5 core extension wire and another end for RGBW led strip. The led connector can not work with 10mm led strip, 3528/5050 rgb led strip, or non-standard 22 awg wire, 20 gauge wire. Suggest refer to updated version. (ASIN:B09L7XSTL8)
-
Alightings 5 pin connector can connect directly to 5pin 12 mm PCB board. Compatible with both 12v and 24v 5050 rgbw led strip.
-
If you want to connect 5Pin WATERPROOF LED light strip, should peel off covered silicon on the surface around soldering line area
-
The led connector suggest match standard 20awg extension cable, pls refer to ASIN: B07CVSJ3DP . without stripping wire, no soldering, connect the 5 core extension wire to get lighting exactly where you want it.
-
Firmly bite through the led strip, don’t like traditional connector only conductive connection, it is a solid connection and much stronger. The package includes 10pcs strip to wire connectors.Provide with a full 30 days money-back guarantee for any unsatisfied order.
About Alightings LED Connector 5 Pin For 12mm RGBW
NOTE: 1.Make sure your section of LED strip lights are 12mm wide 5 PIN Non-Waterproof LED Strip. 2.Should peel off covered silicon on the surface around soldering line area, if you want to connect 5Pin WATERPROOF LED light strip Installation TIPS: Strip End: 1.cut the rgbw led strip straight perfectly, then fully open the clip. 2.push the led strip in until it hits the backing, and pins on the connector make contact, and press hard down for several times with nose pliers to make sure the PINS puncture through led strips. Wire End: 1.have to be separated the 5 wires(20 gauge wire) before you insert them into the rgbw connector. 2. required to press down hard for several times with nose pliers! Ensure the contacts pierces through the insulation on the wire as there are so many non-standard wires on the market! 3. reminder: no stripping of the wires. Just be sure polarity nodes are matched up "+" to "+" and "-" to "-". If you have any problem about installation, pls feel free to contact me. Package: 10pcs Strip to Wire Connectors (AC-SE-N10XB-5)
