We specialize in hard to find items
All Categories
013 Polyurethane O-Ring, 90A Durometer, Round, Translucent, 7/16" ID, 9/16" OD, 1/16" Width (Pack of 25)
Share Tweet
*Price and Stocks may change without prior notice
*Packaging of actual item may differ from photo shown
- Electrical items MAY be 110 volts.
- 7 Day Return Policy
- All products are genuine and original
- Cash On Delivery/Cash Upon Pickup Available
013 Polyurethane O-Ring, 90A Features
-
Made of translucent polyurethane for use with a variety of chemicals and applications
-
Durometer (hardness) of 90A for resistance to penetration
-
Round cross-section to provide a seal between cylindrical overlapping surfaces
-
For use across a wide temperature range from -60 degrees F/-51 degrees C to 212 degrees F/100 degrees C
-
Meets standards defined by Aerospace Standard AS568A
About 013 Polyurethane O-Ring, 90A
This O-ring is made of translucent polyurethane and has a durometer of 90A. It has a round cross-section and can be used across a wide temperature range (-60 degrees F/-51 degrees C to 212 degrees F/100 degrees C). Designed for use in a wide variety of sealing applications, this polyurethane O-ring meet standards defined by Aerospace Standard AS568A, which is the Aerospace Size Standard for O-rings. Polyurethane is resistant to oil, weather, ozone, heat, electricity, abrasion, tearing and many chemicals. It performs well in low temperatures, but is not recommended for continuous use in high temperatures or with super-heated steam. The durometer hardness of this polyurethane O-ring is 90A. Durometers measure the hardness of a material and its resistance to permanent indentation. A higher durometer value indicates greater resistance to indentation. On a scale of 0 to 100, a value of 0 indicates that a sample was completely penetrated, while a value of 100 shows no indentation in the sample. The letter following the number identifies the shore scale, which is either shore A or D. Shore A is used for softer plastics, while shore D is used for harder plastics. O-rings provide a pressure and fluid seal between cylindrically shaped, overlapping mating surfaces and are commonly seen in engines, faucets, flanges, valves, and various cylinders. They are circular in shape, with a round cross section, and a hole in the center, similar to a doughnut. O-rings are available in various AS568A dash sizes, which is the standardized sizing for O-rings, and defines the nominal inside diameter (ID), outer diameter (OD), and cross-sectional (CS) diameter of an O-ring.
