We specialize in hard to find items
(1)
Gold Label Detailing Rapid Tac Vinyl Wrap Application Fluid Kit with Squeegee and Towel…
Share Tweet
*Price and Stocks may change without prior notice
*Packaging of actual item may differ from photo shown
- Electrical items MAY be 110 volts.
- 7 Day Return Policy
- All products are genuine and original
- Cash On Delivery/Cash Upon Pickup Available
Gold Label Detailing Rapid Tac Vinyl Wrap Features
-
32oz Botte of Rapid Tac, GLD Microfiber Towel, and mini Squeegee
-
Get the most control over your vinyl wrap and make any wrapping job fast and easy!
-
Aids in the easy removal of bubbles during vinyl installation.
-
Allows vinyl wrap to be easily repositioned and removed.
-
Bonds vinyl to any smooth surface within approximately 90 seconds after squeegeeing.
About Gold Label Detailing Rapid Tac Vinyl Wrap
Rapid Tac Application Fluid shocked installers by allowing them more control over their applications than ever before. Now what took hours could be accomplished in minutes. Using Rapid Tac Application fluid can often allow a large graphic to be installed with one person where two people were required to perform the same installation dry. Rapid Tac Application Fluid also cleans the substrate without leaving residues ensuring an installation without contamination. It then helps to float the vinyl film until it is properly positioned. Rapid Tac Application Fluid's best feature is that it effectively breaks the surface tension of the adhesive on the film allowing it to flow and bond to the substrate more effectively than even a dry application. It is now possible to achieve a full bond in as little as ninety seconds. Your customers and your reputation will benefit from higher quality applications. Your bottom line will benefit from faster applications and less failures as well. Detailed Use Instructions: STEP 1. Clean surface thoroughly with Rapid Tac and a kitchen paper towel. Do not use other cleaners or solvents. STEP 2. Spray surface again with Rapid Tac, peel backing off decal and place on wet surface. STEP 3. Position decal. Use squeegee to remove fluid, using a good deal of pressure and working from the center out to the edges in all directions. STEP 4. Wait 2 to 3 minutes. Saturate paper cover tape, if any, with Rapid Tac, then remove paper tape. Wipe surface with paper towel.
