We specialize in hard to find items
All Categories
Digilent JTAG-HS3 Programming Cable
Share Tweet
*Price and Stocks may change without prior notice
*Packaging of actual item may differ from photo shown
- Electrical items MAY be 110 volts.
- 7 Day Return Policy
- All products are genuine and original
- Cash On Delivery/Cash Upon Pickup Available
Digilent JTAG-HS3 Programming Cable Features
-
Small, complete, all-in-one JTAG programming/debugging solution for Xilinx FPGAs and SoCs
-
Plugs directly into standard Xilinx JTAG header
-
High-Speed USB2 port that can drive JTAG bus up to 30Mbit/sec (frequency adjustable by user)
-
Open drain buffer on pin 14 allows debugging software to reset the processor core of
-
Uses USB Micro-B connector
About Digilent JTAG-HS3 Programming Cable
The JTAG-HS3 is an affordable high-speed Xilinx FPGA programming solutions. The HS3 builds on the successful JTAG-HS1 by adding an open-drain buffer to pin 14 allowing for the debugging of Xilinx Zynq-SOC processors. It can be attached to target boards using Xilinx's 2x7 connector*, and is compatible with all Xilinx tools, including iMPACT, ChipScope, and EDK. When connected to a PC via a standard A to micro-USB cable, the JTAG HS3 receives its power from USB and can be recognized as a Digilent programming cable, even if the HS3 is not attached to the target board. The JTAG bus can be shared with other devices as the HS3's signals are held in high-impedance, except when actively driven during programming. The HS3 is small and light, allowing it to be held firmly in place by the system board connector. * This is a unique programming header and is not compatible with the 1x6 MTE Digilent JTAG Connector.
