We specialize in hard to find items
(1)
Protopasta 3D Printer Filament | PLA Filament 1.75mm | Matte Fiber HT PLA Walnut Wood | 500g Spool
Share Tweet
*Price and Stocks may change without prior notice
*Packaging of actual item may differ from photo shown
- Electrical items MAY be 110 volts.
- 7 Day Return Policy
- All products are genuine and original
- Cash On Delivery/Cash Upon Pickup Available
Protopasta 3D Printer Filament | PLA Filament Features
-
Walnut Wood HTPLA - A dark brown with elegant sheen and sophisticated texture. Walnut is darker than Chestnut and less red than Mahogany. Great for rigid, artistic prints with no special hardware required
-
Finishing Variety - With the option to heat-treat, wire brush, or polish this filament 1.75 gives you plenty of different choices to give your finished product a different look.
-
Matte Fiber Materials - Fine gold pearl and black flecks, bringing warmth, radiance, and texture with just the right tones and sheen you’d expect for a premium wood-like finish.
-
High Quality - Proto-pasta offers only U.S-made, high-quality 3D printer filament PLA. Using only premium materials with a focus on craftsmanship this PLA 1.75 is one you can trust to get the job done.
-
Easier to Use - This PLA Filament 1.75 mm has been flow-optimized and has less moisture than standard PLAs to help avoid heat soak and to keep mass flow up. This combination of features makes it easier to use than most standard PLAs.
About Protopasta 3D Printer Filament | PLA Filament
Matte Fiber HT PLA Walnut Wood - 500g Spool. Material Data Base resin: HTPLA - Heat Treatable PLA Particle size: less than 250 microns (0.25mm) Odor: low or no Density: Approx. 2.30 g/cc Length (500g): 97m (1.75mm) and 36m (2.85mm) Heat treating: 110C (225F) for 10 min or as required for the desired result Total loss of stiffness (before heat treat): 50-60C (Tg) Total loss of stiffness (after heat treat): 150-175C (melting) Dimension change (before heat treat): 0% X/Y/Z Dimension change (after heat treat): 1.5% shrink X/Y and 1% growth Z typical but please calculate and confirm for your specific print and process Printer Settings Speed: 10-20 mm/s 1st layer, 20-80 mm/s rest of part Nozzle Set-point: 185-215C (hottest on 1st layer for best adhesion) Nozzle Actual: maintain set-point, reduce speed if less than Nozzle Type: Standard or wear-resistant for extended use Nozzle Diameter: 0.6mm or larger preferred, 0.4mm okay with 0.25mm minimum for experts Layer thickness: 0.15-0.20mm recommended for a balance of quality, reliability, and productivity Bed Temperature: Room-60C (over 60C can worsen warp) Bed Preparation: Elmers purple disappearing glue stick or your other favorite PLA surface preparation
