We specialize in hard to find items
All Categories
MKS Gen L V2.0 3D Printer Integrated Motherboard Controller PCB Board A4988/DRV8825/TMC2208/TMC2130 Like Ramps 1.6 MKS Gen V1.4 Mainboard 1PCS
Share Tweet
*Price and Stocks may change without prior notice
*Packaging of actual item may differ from photo shown
- Electrical items MAY be 110 volts.
- 7 Day Return Policy
- All products are genuine and original
- Cash On Delivery/Cash Upon Pickup Available
MKS Gen L V2.0 3D Printer Integrated Motherboard Features
-
❤️ Integrate 2560 and Ramps1.4 one PCB,easier wiring and more stable
-
❤️Use high-quality 4 layer PCB&Use special power chip,support 12V-24V, also Use Marlin firmware,same as configuration way as Ramps1.4, it can replace Ramps1.4 directly
-
❤️ Support a variety of stepper drivers:4988,8825,TMC2208 and TMC2100, and available to work with LCD2004,LCD12864,MKS
-
❤️TFT24/28/32/35 & Available to connect external large stepp drivers Accept 24V input,reduce the heated bed current to 1/4 that slove the Mosfet heat problem efficiently
-
❤️Retail Servos,AUX-1 and AUX-2 interface of Ramps1.4 provide three 5V output and three 12V output interfaces
About MKS Gen L V2.0 3D Printer Integrated Motherboard
Features and advantages: 1. Combine 2560 and ramps1.4 on one board, which solves the problem of cumbersome and easy failure of Ramps1.4 combination interface. 2. Users can replace the motor drive by themselves, support 4988 drive and 8825 drive, TMC2100 drive 3. Reserve an external drive signal, and an external large drive can be used to drive 57 and 86 motors. 4. Using high-quality MOSFET tubes, the heat dissipation effect is better, and the long-term work is stable. 5. Adopt dedicated power chip, support 12V-24V power input, solve the problem of heating and insufficient power supply of Ramps voltage conversion chip. 6. The stable and reliable filter circuit greatly reduces the possibility of interference, and avoids crashes and random running during the printing process. 7. The CH340 serial chip is adopted to reduce the cost while ensuring stability and reliability, and it also solves the problem of the previous 16U2 driver that is difficult to install. 8. It can accept 24V input. Under the same system power, the hot bed current can be reduced to 1/4, which effectively solves the heating problem of the hot bed MOS tube. 9. Use the open source firmware Marlin, the configuration is exactly the same as ramps1.4, which can directly replace Ramps1.4. 10. It can be directly connected to 2004LCD display and 12864LCD display, and can support TFT28 and TFT32 touch screens. 11. The XYZ axis uses different color terminals to correspond to the motor and limit switch, which is convenient for wiring. Attention 1.Make sure positive and negative connection is all right before powering. 2.No plugging and removing the drivers and motors when powering, otherwise it will easily burn the drivers. 3.No adjusting the driver current when the motors are running. Packing List MKS GEN L V2.0 Board*1 USD Cable*1
