We specialize in hard to find items
All Categories
LD-Teemm CO2 Laser Tube, 180W CO2 Laser Tube with Coating 180 watt Length 1900mm Dia. 90mm, Wire Pre-Connected for CO2 Laser Cutter Laser Engraving Cutting Machine
Share Tweet
*Price and Stocks may change without prior notice
*Packaging of actual item may differ from photo shown
- Electrical items MAY be 110 volts.
- 7 Day Return Policy
- All products are genuine and original
LD-Teemm CO2 Laser Tube, 180W CO2 Laser Tube with Features
-
【Parameters and Features】: CO2 laser tube Power: 180w /watt, Outer Diameter: 90mm, Length: 1900mm, This laser tube has Wire Pre-connected and with heat shrinkable sleeves for a higher level of safety, and Add silicone fixing ring to avoid the problem of easy to crack before. Universal for AC 110V and 220V. The laser tube adopts inner discharge tube coated with nano gold catalyst, power is improved.
-
【Warranty】: Within 3 months receiving the laser tube, if there is any problem except for damage caused by man-made or improper operation, we will send a new laser tube for free or give a total refund. Only need to contact us through Amazon
-
【TEM00 Mode】: The output laser is the TEM00 mode, which has high spot concentration, high energy density as well as good and stable spot, making laser machine with better performance
-
【Pre-connected Wire】: There are pre-connected wires for matching positive and negative sides, make installation easy. If you need support during the installation and usage, please send us message through Amazon without hesitation
-
【Wide Application】: The CO2 laser tube is mainly used for laser engraving cutting machine, for engraving acrylic, cardboard, ceramics, fabric, glass, leather, paper, stone, wood and more.
About LD-Teemm CO2 Laser Tube, 180W CO2 Laser Tube With
Installation Instructions 1. Determine the positive and negative poles of the laser tube (the end of the spiral glass tube inside the tube is positive and the light exit is negative). 2. The original positive and negative wires of the machine can be connected to the corresponding joints of the laser tube. (The laser tube is fragile. Avoid local stress when installing and using.) 3. Insert the inlet and the outlet water pipe into the water , usually the positive high-pressure line is the inlet, light outlet is the outlet, pay attention to the low into the high, Otherwise it is easy to cause cracking, burst pipe because the water is not filled. (The cooling water should have at least 20 liters, water temperature under 86℉ or 30℃, change water every 2 weeks.) 4. Adjust the optical path with the laser and test switch on the machine. The final target is to make the laser point enter from the middle of the entrance hole of the laser head, and then adjust the vertical optical path. (You must check whether the water circulation cycle is normal and no bubbles before each use.) 5. When the light path is adjusted, you can cut or use engraving, according to the actual situation to control the power output. Please keep the high voltage electrode dry and clean, and keep it away from the metal to avoid damage to the main board. Notice: The color of the laser from new tube or with sufficient power is purple or pink. The beam is thick and strong. When the power of the laser tube decreases, the beam is thin and the color is white.
