Stronghero3D PLA 3D Printer Filament 1.75mm EX51 Rainbow 1kg(2.2lbs) for ender3

Pay with

Stronghero3D PLA 3D Printer Filament 1.75mm EX51 Features

• PLA silk rainbow 1.75mm, automatic color change in single extruder, 5 colors,purple red,red,yellow, green,blue and colors between them, 15 meters each color;

• High-quality PLA rainbow, manual color change, color change red, orange, yellow, green, blue, purple and transition colors between the two colors, theoretically each color lasts 5-9 meters in length ,can be used in all kinds of FDM 3D printers, director extrusion or Bowden extruder. Printing smoothly, no jam, no warp, no cracking, no bad smell.

• The surface of the material has a very bright color, as smooth as silk, layer strips invisible.PLA raw material is imported from European, no recycled material or reworks material, stable diameter control and no jam

• It is suggested that the nozzle should be used at a temperature of 195-215 ℃. If hairy when printing, adjusted gradually by 5-10 ℃ each time. The platform can be glass, acrylic plate or PEI sheet, heat bed temp 50-70 ℃

• The cooling speed of silk materials is faster than that of ordinary PLA, so the machine can be adjusted slightly, such as the distance between raft and body, the distance between support and body, moving and cooling speed, etc

About Stronghero3D PLA 3D Printer Filament 1.75mm EX51

PLA serials, PLA is very easy to print, some infill pla formulation require the first layer closer to heat bed, a good first layer is key point to avoid warp , and the cooling fan off at the first some layers. Once you don’t print well to slow down the print speed always is a good way. PLA original is brittle, the filament is for 3d printing, not for bending test, filaments are not easy to break without intend to bend. Temp range 185-230 degree on vary 3d printers, if you see hair when printing, adjust temp 5-10 degree each time until you satisfy. PLA can print on many materials , blue tape ,glass, hair spray ,PEI, PVC, all run well. To avoid tangle need a good habit, don’t loose the filament end missing in the filament bunch, you pick a wrong order arrange will mess them severely.