Tilta Nucleus-M: Wireless Lens Control System | Partial Kit IV w/Wireless FIZ Unit & 2 Motors | Follow Focus for Cine Lenses, Mirrorless & DSLR | WLC-T03-K4

Pay with

Tilta Nucleus-M: Wireless Lens Control System Features

• Endless lens control options in the palm of your hand: The Nucleus-M allows you to wirelessly control the motors with either the FIZ hand unit or two handles. If desired, split the control between any of the possible control options for endless possibilities.

• Small, compact hand unit that offers 3-axis control: Control focus, iris, and zoom with the small, form-fitted hand unit. The iris wheel can also be set to act as a speed control for the zoom toggle.

• Perform effortlessly accurate focus pulls: The hand unit offers an intuitive focus mark system that allows you to set marks that vibrate as the hand wheel passes them. Additionally, the hand unit and handles both offer programmable hard stops to allow you to easily focus between a pre-selected range.

• Function as a one-person camera team & keep the form factor of your camera setup to a minimum

• Control any lens: from small DSLR lenses to large cinema zoom lenses

About Tilta Nucleus-M: Wireless Lens Control System

The Nucleus-M is a revolutionary and highly customizable 3-channel wireless lens control system. It allows you to have full control of focus, iris, and zoom on either the FIZ hand unit or between the two wireless hand grips. You can even split control of the channels between the hand unit and wireless hand grips as you see fit with the push of a button. The wireless range of both the hand unit and hand grips is 1,000 feet and with the planned upcoming transmission upgrade, the range can reach up to 1 ¼ miles! This makes it ideal for drone or car-mounted shots. The hand grips can be attached to the included rosette mounts for handheld operation and can also be attached to top bar-based gimbals with the included Nucleus-M Hand Grip to Gimbal Adapters or to ring-based gimbals with the optional Nucleus-M Hand Grip Universal Gimbal Ring Adapters. Each motor has its own built-in motor drive that communicates directly with the hand unit and hand grips. This negates the need to mount a separate MDR to your rig, allowing for a more compact camera setup and a quicker setup time. Simply set the motors and hand unit/hand grips to the same channel and you will have full control. The motors allow for automatic calibration of the lens as well as manual calibration if you are using lenses that don?t have hard end stops at close focus and infinity. The motors are designed to clamp onto 19mm or 15mm rods (with the included rod bushings). This clamp-on design allows you to easily attach and detach the motors without needing to remove any other accessory from your setup. Every motor has a 0.8 mod, 35 tooth, 32 pitch gear attached, which is the standard gear size for cinema lenses. To power the motors, only one power port on your camera rig needs to be used. Simply plug the P-tap power cable into one of the motors and then daisy chain power to the rest of the motors with the short 7-pin to 7-pin cables.