We specialize in hard to find items
All Categories
008 Neoprene O-Ring, 70A Durometer, Round, Black, 3/16" ID, 5/16" OD, 1/16" Width (Pack of 100)
Share Tweet
*Price and Stocks may change without prior notice
*Packaging of actual item may differ from photo shown
- Electrical items MAY be 110 volts.
- 7 Day Return Policy
- All products are genuine and original
- Cash On Delivery/Cash Upon Pickup Available
008 Neoprene O-Ring, 70A Features
-
Made of neoprene (polychloroprene) for use with a variety of fluids and gases from ammonia to Freon
-
Durometer (hardness) of 70A for resistance to penetration
-
Round cross-section to provide a seal between cylindrical overlapping surfaces
-
For use across a wide temperature range from -65 degrees F/-54 degrees C to 275 degrees F/135 degrees C
-
Meets standards defined by Aerospace Standard AS568A
About 008 Neoprene O-Ring, 70A
This black neoprene O-ring has a durometer of 70A, a round cross-section, and can be used across a wide temperature range (-65 degrees F/-54 degrees C to 275 degrees F/135 degrees C). Designed for use in a wide variety of sealing applications, this neoprene O-ring meets standards defined by Aerospace Standard AS568A, which is the Aerospace Size Standard for O-rings. Neoprene (polychloroprene) can have a high tensile strength, and has abrasion, tear, and compression set resistance. It is generally fire resistant and compatible for use with ozone, sunlight, ammonia, Freon, and some hydrocarbons. It also had good adhesion to metal and is often used in metal to rubber bonding applications. Neoprene is vulnerable to ketones, acids, brake fluids and phosphate esters. The durometer hardness of this neoprene O-ring is 70A. Durometers measure the hardness of a material and its resistance to permanent indentation. A higher durometer value indicates greater resistance to indentation. On a scale of 0 to 100, a value of 0 indicates that a sample was completely penetrated, while a value of 100 shows no indentation in the sample. The letter following the number identifies the shore scale, which is either shore A or D. Shore A is used for softer plastics, while shore D is used for harder plastics. O-rings provide a pressure and fluid seal between cylindrically shaped, overlapping mating surfaces and are commonly seen in engines, faucets, flanges, valves, and various cylinders. They are circular in shape, with a round cross section, and a hole in the center, similar to a doughnut. O-rings are available in various AS568A dash sizes, which is the standardized sizing for O-rings, and defines the nominal inside diameter (ID), outer diameter (OD), and cross-sectional (CS) diameter of an O-ring.
