Andis Carbon Infused Steel UltraEdge Dog Clipper Blade, Size-5 Skip Tooth, 1/4-Inch Cut Length (64079)

Pay with

About Andis Carbon Infused Steel UltraEdge Dog Clipper

This UltraEdge dog clipper blade is made from high-carbon steel and processed through a unique carburizing heat treatment that actually adds carbon to the metal. More carbon on the metal means a harder cutting surface. Blades hold a razor sharp edge that will endure prolonged use and more sharpening treatments. Use for the finishing and blending of terriers. Blade is sharpened to exact quality stan dards and is h and-tested before it is shipped. Blade sets should be oiled once a day minimum. Ideally, it should be done before every grooming. After oiling, be sure to use a soft, dry cloth to wipe any oil off the external surfaces to reduce the possibility of getting it on the animal's coat. If the clipper blades leave streaks or slow down, it's a sure sign that the blades need oil. Oiling Blades - Place a few drops of blade oil on the front and side of the cutter blades. Wipe excess oil off blades with a soft, dry cloth. Spray lubricants contain insufficient oil for good lubrication, but are an excellent clipper blade coolant. Cleaning Blades - Immerse blades only while clipper is running in a shallow pan of clipper oil or blade cleaner. After cleaning, turn the clipper off and dry blades with a clean, dry cloth. If blades will still not cut, there may still be some hair trapped between the upper and lower blade. Remove the blade off the clipper and slide the upper blade to one side without loosening the tension spring or moving the upper blade completely out from under the tension spring. Wipe the surfaces of the blades clean with a dry cloth, then place a drop of clipper oil where the upper and lower blades meet and also in the guide slot of the tension spring. Comes in size-5 skip tooth and 1/4-inch cut length. Measures 4-4/5-inch length by 3-1/2-inch width by 1-1/2-inch height.