We specialize in hard to find items
All Categories
EK-FC1080 GTX Ti TF6 Waterblock for MSI GEFORCE GTX 1080 Ti based graphics cards -Nickel/Acetal
Share Tweet
*Price and Stocks may change without prior notice
*Packaging of actual item may differ from photo shown
- Electrical items MAY be 110 volts.
- 7 Day Return Policy
- All products are genuine and original
About EK-FC1080 GTX Ti TF6 Waterblock For MSI GEFORCE GTX
Backplate is just for showcase and it is not included! This product should NOT be installed with any aluminum Fluid Gaming parts EK-FC1080 GTX Ti TF6 is a high-performance full-cover water block for MSI GEFORCE GTX 1080 Ti based graphics cards, based on NVIDIA Pascal architecture (GP102). Please check our Cooling Configurator online compatibility system for detailed compatibility list! This water block directly cools the GPU, RAM, and VRM (voltage regulation module) as water flows directly over these critical areas thus allowing the graphics card and it's VRM to remain stable under high overclocks. EK-FC1080 GTX Ti TF6 water block features a central inlet split-flow cooling engine design for best possible cooling performance, which also works flawlessly with reversed water flow without adversely affecting the cooling performance. This kind of efficient cooling will allow your high-end graphics card to reach higher boost clocks, thus providing more performance during gaming or other GPU intense tasks. Moreover, such design offers great hydraulic performance allowing this product to be used in liquid cooling systems using weaker water pumps. The top also features two pre-drilled slots for 3mm diodes. The sealing is ensured by quality rubber washers. Screw-in brass standoffs are pre-installed and allow for safe, painless installation procedure. The factory backplate of the MSI GeForce GTX 1080 Ti Gaming 11G and MSI GeForce GTX 1080 Ti Gaming X 11G graphics cards is compatible with this water block. G1/4" threaded fittings can be used on both sides of the FC terminal. Up to four EK-FC1080 GTX Ti TF6 water blocks can be used on a single ATX form factor motherboard by using EK-FC Terminal (DUAL, TRIPLE or QUAD type) system or other means of interconnectivity. Please note that the old EK-FC Bridge & Link system is not compatible with this water block.
