All Categories
Prestige Paints 100% acrylic exterior latex paint and primer in one is a high end paint that is intended to be used on exterior surfaces including properly prepared wood, masonry surfaces, cement board siding, vinyl, aluminum and factory primed siding. (Note: When painting vinyl siding do not paint with any color darker than the original siding. Painting with darker colors may cause the siding to warp. ) Actual paint colors may vary from on-screen and printer representation. Surface Preparation: Remove dirt, mildew, grease, wax and soap residue, loose and peeling paint. Glossy areas must be dulled by sanding. Prime all bare, new wood and factory primed wood with an oil base primer. Prime masonry surfaces including cementations siding with a latex primer. Application: Stir or mix paint before using and intermix all containers for color uniformity. Apply as is with a high quality brush, roller or pad painter. Thin sparingly with water if necessary for spraying. Do not overspread. Temperature must be above 50 F (10 C). Average coverage 400 sq. ft. (37 square meters) per gallon (3. 78 L). For best performance, apply two coats of paint on new surfaces after priming. Do not use indoors. Dry Time: Dries in 1 to 2 hours. Allow to dry overnight before recoating. Low temperature or high humidity may increase dry time. Cleanup: Use warm water and soap. A Semi-Gloss finish is more reflective than satin, but is not as shiny as gloss. Semi-gloss finishes provide walls with a shiny appearance and brighten a room's appearance. Off-whites and pale shades of lighter colors are punched up and made brighter by the glossy effect created with these finishes. They are ideal for use in areas with high humidity such as bathrooms and kitchens. They are also the easiest to clean (with light scrubbing or wiping), compared to other finishes. The downside to a gloss finish is that it shows almost every imperfection on a wall or ceiling.