All Categories
Matching Code/ Binding: All receivers are already paired with their respective transmitter during production. If you want to bind it with another transmitter, please follow the instructions below. 1.Ensure you are using AFHDS2A system. 2.Correctly install the battery inside 2.4G transmitter w/o powering it on.3.Insert the binding plug into the BIND channel slot on the receiver. 4.Using a correct receiver battery pack, plug it into VCC channel slot on the receiver. At this time, the LED on receiver should flash, indicating receiver has entered bind status.5.Press and hold the binding button on transmitter, and then switch on the transmitter. 6.Observe the LED light on the receiver. If LED stops flashing and system lit permanently. The binding procedure is completed.(This process takes approximately 5S) 7.Release the binding button on the transmitter and unplug the bind cable. 8.Install the servos to test.9.If the system does not work properly repeat the procedure. (The above binding instruction is only suitable for any Flysky 2.4G products) Transmitter SpecificationsChannels:2Model Type:Car/BoatRF Range:2.405-2.475GHzBandwidth:500 KHzBand:141RF Power:No Higher than 20dBm2.4GHz System:AFHDS2A/AFHDSCode Type:GFSKSensitivity:1024Low Voltage Warning:under 4.2VDSC Port:3.5mm; Output: PPMSteering Range: 70° L: 35° R: 35°Throttle Range: 45° F: 35° B: 15°Charger Port: NoAntenna Length:26mmPower:6V DC 1.5AA*4Display Mode:LED indicatorCertificate:CE, FCCReceiver SpecificationsChannels:3Model Type:Car/BoatRF Range:2.405-2.475GHzBandwidth:500 KHzBand Sum:141RF Receiver Sensitivity:-98dBm2.4G System:AFHDS 2ACode Type:GFSKSensitivity:1024Power:4.0~6.5V DCAntenna Length:26mmPackage Included1 x FS-GT2E Transmitter1 x FS- A3 Receiver1 x Instructions