We specialize in hard to find items
All Categories
YOSUN NP15LP/60003121 Replacement Projector Lamp Bulb for NEC m260x m300x m260xs m300xs m271x Projector Lamp Bulb with Housing
Share Tweet
YOSUN NP15LP/60003121 Replacement Projector Lamp Features
-
YOSUN replacement Projector lamp bulb with same functioning as your original one. Perfectly match and compatible for your Projector.
-
FEATURES: It is the lamp with housing, not only a bare bulb. Same as bright and durable lamp wick as the original bulb.
-
COMPATIBLE MODULES: fit for NEC NP15LP M230X M260W M260X M260XS M271W M271X M300X M300XG M311X NP-M300XC Projector.
-
INSTALLATION AND SAFTY: You will find it is quite easy to install it into your Projector as the ways you are taking out your old lamp. Be aware of the connector make sure it connected well.
-
WARRANTY AND RETURN: New replaced lamp will be shipped to you when your bulb was out of work naturally in 180 days. Refundable issue, please contacts our 24 hours/7 days customer service. It is our appreciations if you need any further assistance.
About YOSUN NP15LP/60003121 Replacement Projector Lamp
Parameter: YOSUN new replacement Projector bulb with housing. Perfect match is only applicable to your correct Projector model. Lamp Life: 3000-4000 hours Warm Noted: Be sure to use an np15lp Projector Lamp for replacement. Be sure to turn off the unit and unplug the power cord before replacing the lamp The lamp remains hot after the unit is turned off with the TV. If you touch the lamp, you may burn your fingers. When you replace the lamp Wait for at least 0.5 hour for the lamp to cool. Do not touch the surface of the lamp If you touch it, wipe off the fingerprints with a soft cloth Installation: 1. Turn off the Projector and unplug the AC power cord. 2. Loosen the screw on the lamp cover with a screwdriver, and then open the lamp cover. 3. Loosen the 2 screws on the lamp with the screwdriver. Hold up the handle, then pull the lamp straight out. 4. Hold the handle of the new lamp and push it in securely until it reaches the end, and then tighten the 2 screws. 5. Close the lamp cover, and then tighten the screws 6. Plug in the AC power cord.
